Inspection Procedure

Check brake fluid level .
Check the amount of brake fluid in the reservoir.
1. OK: Go to next step .
2. NG: Check for fluid leakage, repair brake line and add fluid .
Check brake fluid level warning switch. See step 14 of INSPECTION .
1. OK: Go to next step .
2. NG: Replace brake fluid level warning switch .
Check for open circuit in all the harnesses and components connected to brake warning light. See HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE .
1. OK: Check and replace Translate ECU .
2. NG: Repair or replace harness or connector .