Installation (Avalon, Camry, Camry Solara)

1. Install pad support plates and NEW pads. Install pad wear indicators and anti-squeal shims. Apply disc brake grease to inner anti-squeal shims. DO NOT allow grease to contact rubbing face of pads. On Avalon, wear indictor plate must be face down. On Camry, Camry Solara and Celica, wear indicator plate must be face up.
   NOTE: Pushing piston into caliper bore forces fluid back into master cylinder reservoir. Remove reservoir cap when compressing piston.
2. Press piston into caliper bore. DO NOT let piston dust boot wedge against edge of pads. To complete installation, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS . Check reservoir fluid level.

Fig 1: Exploded View Of Rear Brake Caliper With Internal Shoe Parking Brake (Typical)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002