LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Corolla LE, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> System Tests >> Engine Coolant Temperature Gauge Sender >> Camry & Camry Solara

Camry & Camry Solara

  1. Turn ignition off. Disconnect ECT sender 1-pin connector. Drain cooling system and remove ECT sender. Place probe end of ECT sender and thermometer in a container of water. Connect an ohmmeter between ECT sender terminal and ECT sender body.
  2. Heat water and note resistance reading. See ENGINE COOLANT TEMPERATURE GAUGE SENDER RESISTANCE  table. If resistance is not as specified, replace ECT sender.
scientia non olet · About LEMON Manuals