Manual Shift Test
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Toyota RAV4, 2002 Toyota Highlander, 2002 Toyota Camry, 2002 Lexus RX 300, and 2001 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform manual shift test if no DTCs exist. Manual shift test determines if problem is in electrical circuits or is a mechanical transaxle problem.
- Ensure ignition is off. Disconnect 10-pin solenoid connector located above PNP switch on transaxle.
- Road test vehicle and ensure transaxle gear changes correspond with selector lever position. See GEAR APPLICATION table. If abnormality exists, a mechanical transaxle problem may exist. Turn ignition off.
- Reconnect solenoid connector. Clear DTCs from ECM memory, as disconnecting solenoid connector will set a DTC. See CLEARING DIAGNOSTIC TROUBLE CODES under SELF DIAGNOSTIC SYSTEM.
GEAR APPLICATION
| Selector Lever Position | Gear |
|---|---|
| "D" | Overdrive |
| "4" | 4th |
| "3" | 3rd |
| "2" | 2nd |
| "L" | 1st |
| "R" | Reverse |
| "P" | Park |