LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Corolla CE, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Automatic Transmission Diagnosis - U140E & U140F) >> Diagnostic Tests >> DTC P0753: Shift Solenoid Circuit Malfunction >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Toyota RAV4, 2002 Toyota Highlander, 2002 Toyota Camry, 2002 Lexus RX 300, and 2001 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Access ECM. Disconnect appropriate ECM connector. Using a DVOM, measure resistance between terminal SL1+ and SL1- at ECM connector. See PIN VOLTAGE TESTS .
  2. Resistance should be 5.1-5.5 ohms. If resistance is as specified, replace ECM. See appropriate REMOVAL, OVERHAUL & INSTALLATION article in ENGINE PERFORMANCE. If resistance is not as specified, disconnect 10-pin solenoid connector located above PNP switch on side of transaxle. See Figure. Check circuit continuity between ECM connector terminal SL1+ and solenoid connector terminal No. 5, and between ECM connector terminal SL1- and solenoid connector terminal No. 10.
  3. If continuity exists, check shift solenoid SL2 for malfunction. See appropriate solenoid test under COMPONENT TESTS . If continuity does not exist, check and repair wiring harness or connector between solenoid connector and ECM.
scientia non olet · About LEMON Manuals