Shift Solenoid DSL

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Toyota RAV4, 2002 Toyota Highlander, 2002 Toyota Camry, 2002 Lexus RX 300, and 2001 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For circuit reference, see CONNECTOR IDENTIFICATION and/or WIRING DIAGRAMS .

NOTE: The following information can also be used to diagnose DTC P0770. For testing of shift solenoid SLT, see DTC P1760: SHIFT SOLENOID SLT under DIAGNOSTIC TESTS.

Raise and support vehicle. Remove transaxle oil pan. See LUBRICATION in appropriate AUTOMATIC article in TRANSMISSION SERVICING. Remove shift solenoid DSL. See Figure. Connect battery voltage to solenoid. Apply 71 psi (5 kg/cm² ) of compressed air to solenoid with battery voltage connected. See Fig 1.
With battery voltage connected, air should not pass through solenoid. Disconnect voltage to solenoid. Ensure air passes through solenoid. Replace solenoid as necessary.

Fig 1: Checking Solenoid Operation
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002