LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> RAV4 Base, AWD, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Master Cylinder >> Removal & Installation (Tacoma, Tundra & 4Runner)

Removal & Installation (Tacoma, Tundra & 4Runner)

  1. Unplug fluid level sensor lead. Drain brake fluid from reservoir. Disconnect and plug hydraulic lines. Remove master cylinder-to-power brake unit nuts. Remove master cylinder.
  2. If master cylinder has been overhauled or replaced, check and adjust power brake unit push rod. See POWER BRAKE UNIT PUSH ROD  under ADJUSTMENTS. To install, reverse removal procedure. Bleed brake system. See BLEEDING BRAKE SYSTEM .
scientia non olet · About LEMON Manuals