LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> RAV4 Base, AWD, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Master Cylinder >> Removal & Installation (Sienna)

Removal & Installation (Sienna)

  1. Remove air cleaner assembly. Disconnect fluid level warning switch connector. Remove fluid from master cylinder with syringe. Remove fluid reservoir tank and bracket (2 bolts).
  2. Disconnect brake lines from master cylinder. Remove 2 bolts and master cylinder.
  3. Prior to installation, adjust length of brake booster push rod if necessary. See POWER BRAKE UNIT PUSH ROD  under ADJUSTMENTS.
  4. Install master cylinder in reverse of removal procedure. Use NEW gasket. Fill and bleed system. Check for leaks and adjust pedal, if needed. Bleed clutch system, if equipped.
scientia non olet · About LEMON Manuals