Removal & Installation (RAV4)
- Disconnect fluid level warning switch connector. Remove fluid from master cylinder with syringe. Remove 2 bolts, and move relay box aside. Remove air cleaner housing and hose.
- Disconnect brake lines and 3-way line connector from master cylinder. If equipped with M/T, disconnect clutch reservoir hose. On all models, remove 2 bolts and master cylinder.
- Prior to installation, adjust length of brake booster push rod if necessary. See POWER BRAKE UNIT PUSH ROD under ADJUSTMENTS.
- Install master cylinder in reverse of removal procedure. Use NEW gasket. Fill and bleed system. Check for leaks and adjust pedal, if needed. Bleed clutch system, if equipped.