LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> Corolla VE, Standard >> Labor Times >> Other Variant >> Brakes >> Mechanical - Hydraulic >> Brake Shoes &/Or Pads >> Remove & Replace

Brake Shoes &/Or Pads: Remove & Replace

WARNING: This page is about the Corolla CE, Automatic, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies ToNoteStandard HoursWarranty HoursSkill Level
All2.2B
Front,Both Sides1.0B
Rear,Both Sides1.4B
Combination Procedure: BRAKE HOSE: Replace:
Each AdditionalIncludes: Bleed Brakes.0.2B
OneIncludes: Bleed Brakes.0.3B
Combination Procedure: CALIPER: Overhaul:
Single Piston,OneIncludes: Bleed Brakes.0.5B
Combination Procedure: CALIPER: Replace:
OneIncludes: Bleed Brakes.0.3B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
0.5B
Combination Procedure: DISC ROTOR: Correct:
Lateral Runout,EachCorrect Rotor lateral runout by indexing.0.2B
Combination Procedure: HUB & ROTOR DISC: Clean & Inspect:
Corrosion,EachClean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor.0.2B
Combination Procedure: WHEEL BEARING: Repack:
FWD, Rear0.4B
Front0.8B
Combination Procedure: WHEEL BEARING: Replace:
Disc Brakes,One Side,Rear0.3B
Drum Brakes,One Side,Rear0.1B
Combination Procedure: WHEEL CYLINDER: Overhaul:
One,Off VehicleIncludes: Bleed Brakes.0.5B
One,On VehicleIncludes: Bleed Brakes.0.3B
Combination Procedure: WHEEL CYLINDER: Replace:
OneIncludes: Bleed Brakes.0.3B