Tachometer Resistance (Land Cruiser & Tundra)
Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. Using an ohmmeter, check resistance between tachometer terminals on rear of instrument cluster. See Figure and Figure . See TACHOMETER RESISTANCE table. If resistance is not as specified, replace tachometer.
TACHOMETER RESISTANCE
| Application & Terminals | Ohms | |
|---|---|---|
| Land Cruiser | ||
| A & B | 160 | |
| C & D | 160 | |
| Tundra | ||
| A & B | 140-185 | |
| C & D | 130-175 | |