LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> 4Runner Base, 4WD >> Repair and Diagnosis (Single Page) >> Transmission >> M/T Clutches Manual & Hydraulic >> Removal & Installation >> Clutch Master Cylinder >> Removal & Installation (RAV4)

Removal & Installation (RAV4)

  1. On models equipped with cruise control, remove cruise control actuator cover and cruise control actuator. See Figure. On all models, use syringe to remove brake fluid from clutch master cylinder.
  2. Remove clip and clevis pin from push rod assembly at clutch pedal. Disconnect hydraulic line and reservoir hose at clutch master cylinder. Remove nuts and clutch master cylinder.
  3. To install, reverse removal procedure. Bleed hydraulic system. Adjust clutch pedal height, clutch free play and push rod play. See CLUTCH PEDAL HEIGHT  and CLUTCH PEDAL FREE PLAY & PUSH ROD PLAY  under ADJUSTMENTS.
scientia non olet · About LEMON Manuals