Removal & Installation (Corolla)
- Remove brake booster and position out of the way. See appropriate DISC & DRUM article in BRAKES. Using syringe, remove brake fluid from clutch master cylinder. Disconnect hydraulic line at clutch master cylinder. Remove lower instrument panel finish panel. Remove heater duct. Remove clip and clevis pin from push rod assembly at clutch pedal. Remove nuts and clutch master cylinder.
- To install, reverse removal procedure. Bleed hydraulic system. Adjust clutch pedal height, clutch free play and push rod play. See CLUTCH PEDAL HEIGHT and CLUTCH PEDAL FREE PLAY & PUSH ROD PLAY under ADJUSTMENTS.