Rear Suspension (Avalon, Camry, Camry Solara, 1999 Celica & Corolla)

1. Measure rear camber. See WHEEL ALIGNMENT SPECIFICATIONS . If adjustment is necessary, see appropriate adjustment procedure.
2. Bounce both ends of vehicle several times to settle suspension. Measure length of left and right No. 2 suspension arms. See Fig 1. Ensure lengths of both arms are equal within .039" (1.0 mm).
3. If toe-in is not within specification, adjust toe-in by rotating rear toe adjuster sleeves, located on No. 2 suspension arms. See WHEEL ALIGNMENT SPECIFICATIONS . Tighten lock nuts to specification after adjustment. See TORQUE SPECIFICATIONS .

Fig 1: Identifying No. 2 Suspension Arm (Avalon, Camry, Camry Solara, 1999 Celica & Corolla)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002