LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> 4Runner Base, 4WD >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Disposal Procedures >> On-Vehicle Deployment (Scrapped Vehicles Only) >> Seat Belt Pretensioner

Seat Belt Pretensioner

  1. Before proceeding, See AIR BAG SAFETY PRECAUTIONS . Ensure seat belt pretensioner is not loose. If components are loose, remove and deploy using See OFF-VEHICLE DEPLOYMENT . procedure. Access and disconnect appropriate seat belt pretensioner connector. See SEAT BELT PRETENSIONERS  under REMOVAL & INSTALLATION.
  2. Connect Deployment Tools (09082-00700 and 09082-00740) to appropriate seat belt pretensioner connector. Position deployment tool at least 33 feet from front of vehicle. Buckle front seat belt and ensure there is no looseness or slack in inner belt and outer belt. Close all doors and windows of vehicle. Connect deployment tool Red clip to positive battery terminal and Black clip to negative battery terminal.
  3. Ensure no one is inside vehicle or within 33 feet of vehicle. Press activation switch to deploy air bag. Because of heat, DO NOT touch air bag for at least 30 minutes after deployment. Scrap vehicle with air bag(s) still installed.
scientia non olet · About LEMON Manuals