LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> 4Runner Base, 4WD >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul & Installation - 4-Cylinder >> Ignition Systems >> Ignition Coil >> Removal & Installation (Tacoma Calif. Emission Vehicles & 4Runner Calif. Emission Vehicles)

Removal & Installation (Tacoma Calif. Emission Vehicles & 4Runner Calif. Emission Vehicles)

  1. Disconnect electrical connector from ignition coil mounted on valve cover. Note location of ignition coil for installation reference. Remove ignition coil retaining bolt and ignition coil from valve cover.
  2. To install, reverse removal procedure. Tighten ignition coil retaining bolt to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals