LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> 4Runner Base, 4WD >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul & Installation - 4-Cylinder >> Engine Sensors & Switches >> Airflow Meter >> Removal & Installation (Tacoma & 4Runner)

Removal & Installation (Tacoma & 4Runner)

  1. Ensure ignition is off. Disconnect electrical connector at airflow meter. Airflow meter is located between air intake hose and upper cap on air cleaner assembly. Airflow meter is bolted to upper cap on air cleaner assembly.
  2. Disconnect necessary hoses for removal of upper cap on air cleaner assembly. Loosen clamp on air intake hose at airflow meter. Loosen retaining clips that retain upper cap on air cleaner assembly.
  3. Remove upper cap on air cleaner assembly with airflow meter from air cleaner assembly. Remove airflow meter mounting nuts, airflow meter and gasket from upper cap.
  4. To install, reverse removal procedure using NEW gasket. Tighten airflow meter mounting nuts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals