LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> 4Runner Base, 4WD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.4L, 2.7L >> Removal & Installation >> Front Cover Oil Seal >> Removal & Installation (Oil Pump Installed)

Removal & Installation (Oil Pump Installed)

  1. Remove accessory drive belts and crankshaft pulley. Pry oil seal from oil pump cover. DO NOT damage sealing surfaces.
  2. To install, apply grease to lip of NEW oil seal. Using hammer and Oil Seal Installer (SST 09223-50010), install oil seal until oil seal surface is even with edge of oil pump cover. To install remaining components, reverse removal procedure.
scientia non olet · About LEMON Manuals