LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> 4Runner Base, 4WD >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Instrument Panels >> System Tests >> Engine Coolant Temperature Gauge >> Engine Coolant Temperature Gauge Circuit Test

Engine Coolant Temperature Gauge Circuit Test

  1. Disconnect coolant temperature sender connector. See ENGINE COOLANT TEMPERATURE SENDER LOCATION  table. Turn ignition switch to ON position. Temperature gauge should indicate COOL. Turn ignition switch to OFF position. Connect a 12-volt, 3.4-watt test light between coolant temperature sender harness connector terminal and ground.
  2. Turn ignition switch to ON position. Test light should be on and temperature gauge should slowly move to HOT. If gauge functions as specified, replace sending unit. If gauge does not function as specified, perform TEMPERATURE GAUGE RESISTANCE TEST .
scientia non olet · About LEMON Manuals