LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> 4Runner Base, 4WD >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Instrument Panels >> Removal & Installation >> Instrument Cluster >> Removal & Installation (Tacoma)

Removal & Installation (Tacoma)

  1. Disable air bag system, remove driver's air bag and steering wheel. See AIR BAG RESTRAINT SYSTEMS article. Remove lower finish panel. Remove steering column covers.
  2. Remove starter switch bezel (if necessary). Remove cluster finish panel retaining screws. Using flat-blade screwdriver, pry instrument cluster finish panel loose from 3 retaining clips.
  3. Remove 4 instrument cluster retaining screws. Pull instrument cluster out far enough to disconnect wiring harness connectors. Remove instrument cluster. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals