LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> 4Runner Base, 4WD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Power Sun Roof >> Component Tests >> Limit Switches >> Camry (USA Built)

Camry (USA Built)

NOTE: The Camry may have been manufactured by Toyota Motor Mfg. U.S.A. (USA built), or manufactured by Toyota Motor Corp. Japan (Japan built). Ensure correct test procedure is being used.
  1. Unplug sun roof motor and limit switch connector. See Fig 1. For limit switch No. 1, continuity should not exist between terminals No. 3 and 5 with switch pin released. With pin pressed in, continuity should exist between terminals No. 3 and 5.
  2. For limit switch No. 2, continuity should not exist between terminals No. 3 and 6 with switch pin released. With pin pressed in, continuity should exist between terminals No. 3 and 6.
  3. For limit switch No. 3, continuity should not exist between terminals No. 3 and 4 with switch pin released. With pin pressed in, continuity should exist between terminals No. 3 and 4. Replace switch if continuity is not as specified.
Fig 1: Identifying Sun Roof Motor & Limit Switch Terminals (Camry - USA Built)
G97D11240Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002