LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> 4Runner Base, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Component Tests >> Front Wiper Motor Test >> Camry, Camry Solara, Tacoma & Tundra

Camry, Camry Solara, Tacoma & Tundra

  1. Using a 12-volt battery, connect jumper wire from positive battery terminal to wiper motor terminal No. 5. See Figure. Connect another jumper wire from negative battery terminal to wiper motor terminal No. 4. Motor should operate at low speed.
  2. Remove jumper wire from terminal No. 5. Reconnect jumper wire to wiper motor terminal No. 3. Motor should operate at high speed. Remove jumper wire from terminal No. 3 and reconnect jumper wire to wiper motor terminal No. 5. With motor running at low speed, stop motor at any position except PARK position by disconnecting jumper wire from terminal No. 5. On Camry and Camry Solara, install jumper wire between wiper motor terminals No. 3 and 5. On Tacoma and Tundra, install jumper wire between wiper motor terminals No. 1 and 5.
  3. On all models, connect positive battery terminal jumper wire to wiper motor terminal No. 2. Connect negative battery terminal jumper wire to wiper motor terminal No. 4. Motor should start running and then stop at PARK position. Replace motor if operation is not as specified. See FRONT WIPER MOTOR  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals