Removal & Installation (Celica)
- Remove left front wheel. Remove master cylinder. See MASTER CYLINDER. Disconnect vacuum hose from booster. Remove lower instrument panel pad. Remove pedal return spring. Disconnect push rod at brake pedal.
- Remove ignition coil and igniter. Disconnect flexible brake line from left front caliper. On ABS-equipped vehicles, remove 3 brakelines from clamp on firewall.
- On all models, remove power brake booster unit. To install, reverse removal procedure. Tighten nuts to specification. See TORQUE SPECIFICATIONS . Check and adjust push rod. See POWER BRAKE UNIT PUSH ROD under ADJUSTMENTS . Bleed brake system. See BLEEDING BRAKE SYSTEM.