LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1998 >> RAV4 Base, 2D Utility, AWD, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Rear Axle Bearing & Oil Seal >> Removal & Installation (RAV4 2WD)

Removal & Installation (RAV4 2WD)

  1. Remove axle shaft cotter pin and lock cap. While apply brakes, remove axle shaft nut. Raise and support rear of vehicle.
  2. Remove wheel. Remove brake drum. See REAR BRAKE DRUM. Remove brake shoes. See REAR DRUM BRAKE SHOES. Remove parking brake cable from backing plate. Disconnect brake fluid line from wheel cylinder.
  3. Remove 4 bolts securing hub, bearing, backing plate and axle to suspension arm. Remove components as an assembly. Using puller, remove bearing from hub. Remove inner bearing race from outside of hub. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals