LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1998 >> RAV4 Base, 2D Utility, AWD, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Rear Axle Bearing & Oil Seal >> Installation (Previa)

Installation (Previa)

  1. Drive NEW oil seal into axle shaft housing to depth of .138" (3.51 mm) for disc brake models and .236" (5.99 mm) for drum brake models.
  2. On disc brake models, place NEW retainer gasket and bearing outer retainer on backing plate. Using a socket and hammer, install bolts. Install backing plate to axle shaft.
  3. On drum brake models, install bearing outer retainer to axle shaft. On all models, press NEW bearing onto axle shaft. Heat inner retainer to 302°F (150°C) in an oil bath. Clean retainer and axle shaft of oil and grease. While still hot, press inner retainer onto axle shaft.
  4. Using a press, install speed sensor rotor and NEW oil seal (if equipped). Install end gasket. To complete installation, reverse removal procedure. Bleed brake system. See BLEEDING BRAKE SYSTEM .
scientia non olet · About LEMON Manuals