Removal & Installation (RAV4 & Sienna)

Raise and support vehicle. Remove front wheel. Hold sliding pin on bottom and loosen installation bolt. Remove installation bolt and rotate caliper upward. Suspend caliper aside with wire.
On RAV4, remove pads, 4 anti-squeal shims and 2 pad support plates. See Fig 1.
On Sienna, remove 2 anti-squeal springs, pads, 4 anti-squeal shims, 4 pad support plates and wear indicators. See Fig 1. To install, reverse removal procedure. Tighten lower caliper bolt to specification. See TORQUE SPECIFICATIONS . Check reservoir fluid level.

Fig 1: Exploded View Of Front Brake Caliper Assembly (RAV4 Shown; Sienna Is Similar)