No. 1 Vehicle Speed Sensor (VSS)
- Disconnect electrical connector from No. 1 VSS, located on top of transaxle. See Figure. Connect positive battery lead to terminal No. 1 and negative lead to terminal No. 2. Connect positive lead of voltmeter to terminal No. 3 and negative lead to terminal No. 2. See Fig 1.
- Raise and support one vehicle front wheel. Rotate wheel and monitor voltmeter. Ensure voltage changes from zero to 11 volts. Voltage should change 4 times per each revolution of speed sensor shaft. Replace speed sensor if voltage does not change as specified.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002