DTC 11 Or 15: Actuator Motor Circuit
- Ensure actuator control plate is NOT in fully opened (clockwise) position or fully closed (counterclockwise) position before disconnecting actuator connector. See Figure. Disconnect Black 4-pin actuator connector. See Figure.
- Measure resistance between actuator terminals No. 1 (Pink wire) and No. 2 (Red/Black wire). If resistance is greater than 4.2 ohms, go to next step. If resistance is 4.2 ohms or less, replace cruise control actuator and retest system.
- Check wiring harness and connectors between actuator motor and cruise control ECU. Repair as necessary. If wiring harness and connectors are okay, replace cruise control ECU and retest system.