LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1998 >> Avalon XLS >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transmission Overhaul - A-540E, A-540H & A-541E >> Torque Converter >> Converter Sleeve RUNOUT Test

Converter Sleeve RUNOUT Test

  1. Temporarily mount torque converter to drive plate. Mount a dial indicator with needle resting on converter sleeve. See Figure. Rotate converter. If runout exceeds .012" (.30 mm), ensure converter is properly mounted to drive plate.
  2. If converter is properly mounted and runout exceeds specifications, replace torque converter. Mark position of converter to ensure correct installation. Remove converter from drive plate.
scientia non olet · About LEMON Manuals