Valve Body Assembly: Removal
- Clean exterior of transaxle. Remove oil pan plug. Drain transaxle. Remove oil pan and gasket. Discard gasket. Remove oil strainer. Note location of magnets in oil pan. Remove magnets. Examine particles in pan. Steel (magnetic) particles indicate bearing, gear, or plate wear. Brass (non-magnetic) particles indicate bushing wear.
- Remove tube bracket. Note location of oil tubes, and remove oil tubes. Disconnect solenoid wiring harness connector(s). Remove manual detent spring. Remove manual valve. Disconnect throttle cable from cam. Remove valve body assembly. Remove 2nd brake apply gasket.