LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1998 >> Avalon XLS >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transmission Overhaul - A-540E, A-540H & A-541E >> On-Vehicle Service >> Park/Neutral Position (PNP) Switch >> Removal & Installation

Removal & Installation

  1. Disconnect park/neutral position (PNP) switch connector. Remove nut and disconnect shift control cable. Remove nut, washer and manual shaft lever. Pry back locking tab on manual shaft washer and remove nut. Remove 2 bolts and remove park/neutral position (PNP) switch.
  2. Install PNP switch to manual shaft. Install 2 bolts finger tight. Install NEW locking plate. Install nut and tighten to 61 INCH lbs. (6.9 N.m). Stake nut with locking plate. Install manual shaft lever, washer and nut. Tighten nut to 115 INCH lbs. (13 N.m). Install shift control cable and nut. Tighten nut to 11 ft. lbs. (15 N.m). Adjust switch by aligning groove and neutral basic line. Tighten 2 bolts to 48 INCH lbs. (5.4 N.m). Ensure engine starts in Park and Neutral.
scientia non olet · About LEMON Manuals