LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1998 >> Avalon XLS >> Repair and Diagnosis (Single Page) >> Suspension >> Front Suspension >> Suspension - Front >> Removal & Installation >> Wheel Bearing >> Installation (Celica)

Installation (Celica)

  1. Using an arbor press and Seal Driver (09608-32010), press NEW bearing into steering knuckle. Install hub bearing outer race onto hub bearing. Using seal driver and Bushing Driver (09710-14012), drive NEW outer oil seal into steering knuckle.
  2. Install dust cover. Apply multipurpose grease to oil seal lip and bearing. Install hub bearing inside race onto hub bearing. Using Bearing Driver (09310-35010), press hub into steering knuckle. Install snap ring into steering knuckle.
  3. Using seal driver and Bushing Driver (09710-14012), install NEW inner oil seal flush with end surface of steering knuckle. Install lower ball joint (if removed). Position NEW dust deflector into steering knuckle so hole in dust deflector (for ABS speed sensor) aligns with hole in steering knuckle.
  4. Using Seal Driver (09608-35014), install dust deflector. To complete installation, reverse removal procedure. Tighten all nuts and bolts to specification. See TORQUE SPECIFICATIONS . Check front end alignment. See WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT section.
scientia non olet · About LEMON Manuals