LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1998 >> Avalon XLS >> Repair and Diagnosis (Single Page) >> Suspension >> Front Suspension >> Suspension - Front >> Removal & Installation >> Wheel Bearing >> Installation (Avalon, Camry & Sienna)

Installation (Avalon, Camry & Sienna)

  1. Using an arbor press and Seal Driver (09608-32010), press NEW bearing into steering knuckle. Install NEW snap ring. Install dust cover. Using Bearing Driver (09310-35010), press axle hub into steering knuckle. Install lower ball joint (if removed).
  2. Position NEW dust deflector into steering knuckle so hole in dust deflector (for ABS speed sensor) is aligned with hole in steering knuckle. Using Seal Driver (09316-60010), install NEW dust deflector.
  3. To complete installation, reverse removal procedure. Tighten all nuts and bolts to specification. See TORQUE SPECIFICATIONS . Check front end alignment. See WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT section.
scientia non olet · About LEMON Manuals