Removal (All Models)

Ensure front wheels are in straight-ahead position. Turn ignition off. Disconnect and shield negative battery cable.
Remove screw covers, screws and lower instrument cluster trim panel(s). Loosen steering wheel pad Torx screws until groove along screw circumference catches on screw case. See Fig 1.

Fig 1: Removing Steering Wheel Pad (Typical)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Pull steering wheel pad from steering wheel and disconnect air bag. Remove steering wheel pad assembly. Place steering wheel pad assembly on a flat surface with pad cover facing upward.
WARNING: Place steering wheel pad assembly on workbench. Pad surface MUST face up. If assembly is stored face down, accidental air bag deployment could propel assembly and cause serious bodily injury.
Place a mark on steering wheel and mainshaft for installation reference. Remove steering wheel nut. Disconnect connector. Using steering wheel puller, remove steering wheel.