Spiral Cable: Removal
Before proceeding, see SERVICE PRECAUTIONS . Turn ignition switch to LOCK position. Disconnect and shield negative battery cable. Wait at least 90 seconds. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE. Remove steering wheel. See STEERING WHEEL . Remove lower finish panel assembly. Remove upper and lower steering column covers. Remove 4 screws and spiral cable from combination switch.
NOTE:
It may be necessary to remove combination switch and spiral cable as an assembly, and then separate components.
WARNING:
Spiral cable mating marks must be properly aligned or steering wheel may not turn completely, or flat cable inside spiral cable may be severed, disabling air bag system