LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1998 >> Avalon XLS >> Repair and Diagnosis (Single Page) >> Engine Performance >> Testing & Diagnosis >> Engine Controls - System/Component Tests - V6 & V8 >> Engine Sensors & Switches >> Airflow Meter >> Land Cruiser & LX470

Land Cruiser & LX470

  1. Turn ignition off. Disconnect electrical connector from airflow meter. Airflow meter is bolted to the top side of air intake hose, near upper cap on air cleaner assembly. Remove airflow meter and note airflow meter terminal identification. See Figure-11.
  2. Using ohmmeter, check resistance between terminals E2 and THA. Resistance should be within specification in relation to the temperature. See AIRFLOW METER RESISTANCE  table. Replace airflow meter if resistance is not within specification.
  3. To test airflow meter operation, ensure electrical connector is installed on airflow meter. Connect voltmeter leads to proper terminals on the airflow meter with electrical connector installed. See Figure-14.
  4. Turn ignition on. Apply air into airflow meter and note voltage reading. See Figure-14. While air is being applied, voltage reading should fluctuate. Replace airflow meter if voltage does not fluctuate. Remove voltmeter.
scientia non olet · About LEMON Manuals