LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1998 >> Avalon XLS >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul - V6 & V8 >> Engine Sensors & Switches >> Power Steering Pressure Switch >> Removal & Installation (Tacoma, T100 & 4Runner)

Removal & Installation (Tacoma, T100 & 4Runner)

  1. Power steering pressure switch is screwed into side of pressure hose at the power steering pump. Disconnect electrical connector at power steering pressure switch. Remove power steering pressure switch.
  2. To install, reverse removal procedure. Tighten power steering pressure switch to specification. See TORQUE SPECIFICATIONS . Fill power steering pump with Dexron-III ATF.
scientia non olet · About LEMON Manuals