LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1998 >> Avalon XLS >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul - V6 & V8 >> Engine Sensors & Switches >> Park/Neutral Position (PNP) Switch >> Installation (Land Cruiser & LX470)

Installation (Land Cruiser & LX470)

  1. Using NEW lock plate, install PNP switch on transmission. Install and tighten PNP switch retaining nut and PNP switch retaining bolt to specification. See TORQUE SPECIFICATIONS . Bend over tab on lock plate against PNP switching retaining nut.
  2. Reinstall control lever and nut on PNP switch. Reconnect shift linkage on control lever. Check that engine starts only with shift lever in Park and Neutral. If PNP switch adjustment is required, go to next step.
  3. Ensure parking brake is applied. Place shift lever in Neutral. Loosen PNP switch retaining bolt.
  4. Rotate PNP switch so neutral base line aligns with the groove. See Figure. Tighten PNP switch retaining bolt to specification. See TORQUE SPECIFICATIONS .
  5. Ensure continuity exists between specified terminals on PNP switch in relation to shift lever position. See appropriate SYSTEM/COMPONENT TESTS article. Reinstall electrical connector.
scientia non olet · About LEMON Manuals