LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1998 >> Avalon XLS >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul - V6 & V8 >> Engine Sensors & Switches >> Park/Neutral Position (PNP) Switch >> Installation (Avalon & Camry A/T & Sienna)

Installation (Avalon & Camry A/T & Sienna)

  1. Using NEW lock plate, install PNP switch on transaxle. Install and tighten PNP switch retaining nut and PNP switch retaining bolts to specification. See TORQUE SPECIFICATIONS . Bend over tab on lock plate against PNP switching retaining nut.
  2. Reinstall control lever, washer and nut on PNP switch. Tighten nut for control lever to specification. See TORQUE SPECIFICATIONS . Reconnect shift cable on control lever. Check that engine starts only with shift lever in Park and Neutral. If PNP switch adjustment is required, go to next step.
  3. Ensure parking brake is applied. Place shift lever in Neutral. Loosen PNP switch retaining bolts.
  4. Rotate PNP switch so neutral base line aligns with the groove. See Figure. Tighten PNP switch retaining bolts to specification. See TORQUE SPECIFICATIONS .
  5. Ensure continuity exists between specified terminals on PNP switch in relation to shift lever position. See appropriate SYSTEM/COMPONENT TESTS article. Reinstall electrical connector.
scientia non olet · About LEMON Manuals