LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1998 >> Avalon XLS >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul - V6 & V8 >> Engine Sensors & Switches >> BRAKELIGHT Switch >> Removal & Installation (Avalon, Land Cruiser, LX470 & Sienna)

Removal & Installation (Avalon, Land Cruiser, LX470 & Sienna)

  1. Disconnect electrical connector at brakelight switch. Brakelight switch is located near top of brake pedal. Loosen lock nut on brakelight switch. Remove brakelight switch from mounting bracket.
  2. Depress brake pedal about.39" (10.0 mm) and hold brake pedal in this position. Install electrical connector on brakelight switch. Install brakelight switch in mounting bracket.
  3. Rotate brakelight switch until brakelights go off. Tighten lock nut on brakelight switch. Release brake pedal. Ensure brakelights are off when brake pedal is released and brakelights come on when brake pedal is depressed about.39" (10.0 mm).
scientia non olet · About LEMON Manuals