LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1998 >> Avalon XLS >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Engine Mechanical (3.0L V6) >> Removal & Installation >> Engine >> Removal (Sienna)

Removal (Sienna)

  1. Release fuel pressure. See FUEL PRESSURE RELEASE . Drain cooling system and engine oil. Remove hood, battery and battery tray. Remove cowl top panel assembly. See Figure. Remove heater air duct. Remove air cleaner cap and airflow meter with air cleaner hose. Remove air filter and air cleaner case.
  2. Remove cruise control actuator and bracket. Remove radiator and coolant reservoir tank. Disconnect A/T oil cooler pipe. Disconnect necessary A/C lines, coolant hoses, electrical connections, fuel lines and vacuum hoses. Disconnect shift control cable from transaxle. Remove front exhaust pipe.
  3. Remove fender apron seals. Raise and support vehicle. Remove axle shafts. Disconnect stabilizer bar links and intermediate shaft assembly. Disconnect power steering hose from power steering reservoir and reservoir pipe. Remove cover under engine. Attach Engine Hangers (SST 12282-20020). Attach sling device to hangers.
  4. Remove right engine mount. Remove engine mount control rod and No. 2 right engine mount bracket. Remove 4 lower braces from underneath vehicle. Lower engine, transaxle, and front suspension assembly from vehicle.
scientia non olet · About LEMON Manuals