LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1998 >> Avalon XLS >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Engine Mechanical (3.0L V6) >> Removal & Installation >> Engine >> Installation (Avalon & Camry)

Installation (Avalon & Camry)

  1. To install, reverse removal procedure. Tighten all fasteners to specification. See TORQUE SPECIFICATIONS .
  2. When installing axle shafts, install NEW snap ring on end of axle shaft. Coat axle shaft splines and sliding surfaces with gear oil. Install axle shafts in transaxle with opening of snap ring facing downward.
  3. Ensure left (driver's side) axle shaft will move inward and outward about .079-.118" (2.00-3.00 mm) after being installed. Ensure axle shaft cannot be pulled from transaxle.
  4. When installing right (passenger's side) axle shaft, install NEW snap ring and NEW axle shaft bearing retainer bolt. Tighten axle shaft bearing retainer bolt to specification. See TORQUE SPECIFICATIONS .
  5. To install remaining components, reverse removal procedure. Adjust fluid levels and control cables (if necessary).
scientia non olet · About LEMON Manuals