LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1998 >> Avalon XLS >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Engine Mechanical (3.0L V6) >> Removal & Installation >> Crankshaft Front Seal >> Removal & Installation (Oil Pump Installed)

Removal & Installation (Oil Pump Installed)

  1. Remove timing belt and crankshaft sprocket. See TIMING BELT. Using a knife, cut seal lip from oil seal. Pry oil seal from oil pump body. DO NOT damage sealing surfaces.
  2. To install, apply grease to lip of new oil seal. Using hammer and Oil Seal Installer (SST 09223-00010), install oil seal until oil seal surface is even with oil pump body. To install remaining components, reverse removal procedure.
scientia non olet · About LEMON Manuals