LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1998 >> Avalon XLS >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Axle Shafts - Front >> Removal, Disassembly, Reassembly & Installation >> Axle Shafts >> Installation (Paseo & Tercel)

Installation (Paseo & Tercel)

  1. To install, reverse removal procedure. Before installing axle shafts, install NEW snap ring onto end of axle shaft. Coat axle shaft seals in transaxle with grease.
  2. Install axle shaft by lightly tapping axle shaft into transaxle. Ensure axle shaft will move inward and outward approximately .079-.120" (2.00-3.00 mm) and cannot be pulled from transaxle.
  3. To install remaining components, reverse removal procedure. Tighten bolts/nuts to specification. See TORQUE SPECIFICATIONS . Fill transaxle with Dexron-II (A/T models) or 75W-90 gear oil with API GL-4 or GL-5 rating (M/T models).
scientia non olet · About LEMON Manuals