Clearing Codes
WARNING: This page is about a different car, the 1995 Toyota Tercel. However, it is still accessible from the selected car via links, so may be relevant.
- At DLC, connect a jumper wire to terminal Tc. See Figure. Connect another jumper wire to terminal AB. Turn ignition switch to ACC or ON position. Wait about 6 seconds.
- Starting with terminal Tc, apply body ground alternately to terminal Tc and terminal AB twice each, in cycles of 1/2 to 1 1/2 seconds (sequence is: Tc, AB, Tc, AB). Finally, keep applying body ground to terminal Tc until air bag warning light flashes quickly, indicating codes are cleared.
NOTE:
When alternately connecting jumper probes to terminals, simultaneously release one probe from one terminal while connecting other probe to other terminal. If time interval between probings exceeds 0.2 seconds, codes will not clear.