LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1996 >> Tercel DX, 2D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Air Bag Restraint System) >> Disposal Procedures >> On-Vehicle Deployment (Scrapped Vehicles Only)

On-Vehicle Deployment (Scrapped Vehicles Only)

WARNING: This page is about a different car, the 1995 Toyota Tercel. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, follow service precautions. See SERVICE PRECAUTIONS . Disable SRS. See DISABLING & ACTIVATING AIR BAG SYSTEM . Ensure steering wheel, steering wheel pad and passenger-side air bag are not loose. If components are loose, deploy air bag(s) using OFF-VEHICLE DEPLOYMENT  procedure.
  2. If deploying steering wheel pad, disconnect spiral cable connector under steering column. If deploying passenger-side air bag, disconnect passenger-side air bag connector, accessible through glove box door finish plate. See Figure. For either air bag, connect Deployment Tool (09082-00700) connector to air bag connector. Position deployment tool at least 33 feet from front of vehicle.
  3. Close all doors and windows of vehicle. Connect deployment tool Red clip to positive battery terminal and Black clip to negative battery terminal. Ensure no one is inside or within 33 feet of vehicle. Press activation switch to deploy air bag. Because of heat, DO NOT  touch air bag for at least 30 minutes after deployment.
scientia non olet · About LEMON Manuals