Rear Brake Drum: Installation

Pack wheel bearings with multipurpose grease. Coat inside of axle hub and grease cap with multipurpose grease. Install brake drum, outer bearing and thrust washer. Temporarily install bearing nut. Tighten bearing nut to 22 ft. lbs. (30 N.m) while turning drum. Loosen nut until it can be turned by hand. Using spring scale, measure rotational preload.
Slowly tighten bearing nut until rotational preload is 0-2.6 lbs. (0-1.18 kg) on Tercel, or 0-2.2 lbs. (0-1.0kg) on Paseo. Install nut lock and NEW cotter pin. Install grease cap. To complete installation, reverse removal procedure. Check and adjust rear brake shoe clearance. See REAR BRAKE SHOES .

Fig 1: Exploded View Of Rear Drum Brakes