LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1995 >> Tercel Base, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical (1.5L 4-CYL) >> Removal & Installation >> Fuel Pressure Release

Fuel Pressure Release

NOTE: Manufacturer recommends disconnecting electrical connector at electric fuel pump and operating engine until engine stalls before loosening fuel line connection.
  1. Remove rear seat cushion and floor panel cover for access to electrical connector for electric fuel pump. Electric fuel pump is located in fuel tank. Disconnect electrical connector for electric fuel pump.
  2. Start engine and allow engine to idle until engine stalls. Turn ignition off. Reconnect electrical connector for electric fuel pump. Reinstall floor panel cover and rear seat cushion.
  3. Disconnect negative battery cable. Place approved gasoline container under fuel line. Cover fuel line connection with shop towel.
  4. Slowly loosen fuel line connection to release fuel pressure. Once fuel pressure is released, fuel system components may be serviced.
scientia non olet · About LEMON Manuals