Avalon, Camry, Celica, Corolla 1.8L 7A-FE, Land Cruiser, MR2, Paseo, Previa Supercharged, RAV4, Supra Non-Turbo, Tacoma 2WD 3.4L V6 & 4WD, T100 & 1996 4Runner

Ensure accelerator pedal is in released position and throttle valve is fully closed. Check that no slack exists in throttle valve cable at the throttle body. Measure distance between outer cable and the stopper on throttle valve cable. See Fig 1.
Distance should be 0-.04" (0-1.0 mm). If distance is not within specification, loosen adjusting nuts on throttle valve cable. Tighten or loosen adjusting nuts until proper distance is obtained. Tighten adjusting nuts. Recheck distance once adjusting nuts are tightened.

Fig 1: Measuring Distance On Typical Throttle Valve Cable (Avalon, Camry, Celica, Corolla 1.8L 7A-FE, Land Cruiser, MR2, Paseo, Previa Supercharged, RAV4, Supra Non-Turbo, Tacoma 2WD 3.4L V6 & 4WD, T100 & 1996 4Runner)