LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1995 >> Tercel Base, Automatic >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transmission Servicing - A/T >> Adjustments >> Gearshift Linkage >> Pickup 4WD With 3.0L V6 & 1995 4Runner 4WD With 3.0L V6

Pickup 4WD With 3.0L V6 & 1995 4Runner 4WD With 3.0L V6

  1. Apply parking brake. Loosen nut(s) for control rod at shift lever on driver's side of transmission. The control rod fits between shifting mechanism at rear of the transmission and the shift lever on side of transmission. The shifting mechanism has a rod which goes to the gearshift.
  2. Pull control rod fully backward toward rear of vehicle to the Park position. Push control rod forward 2 notches to the Neutral position.
  3. Ensure gearshift is in Neutral. While holding gearshift lightly toward the Reverse position, tighten nut(s) for control rod. Supra, Tacoma With Floor Shift, 1995 4Runner 2WD & 4WD 2.4L 4-Cyl., & 1996 4Runner
  4. Apply parking brake. Loosen nut for control rod at the gearshift. See Figure. Pull control rod fully backward toward rear of vehicle to the Park position.
  5. Push control rod forward 2 notches to the Neutral position. Ensure gearshift is in Neutral. Tighten nut for control rod at gearshift.
  6. Start engine. Ensure vehicle moves forward when shifting gearshift from Neutral to Drive, and in reverse when shifting to Reverse.
scientia non olet · About LEMON Manuals